- High torsional stiffness
- 0.1% accuracy
- Capacities 12K & 36K lb-in
- AND 20006 & 10266 configured flanges
- SAE 4340 Alloy Steel
- Supplied with mating connector
High Capacity Hollow Flange Reaction Torque Sensor Model T123
Description
The T123 is designed to support the housing of motors, generators, pumps, and similar devices and accurately measure the non-rotating reaction torque values where the rotating member of the device under test is passed through the center of the sensor. The T123, with inherent low-end measurement capability, can be installed at the driver or absorber end of the measurement chain. The flanges, pilot diameters and bolting studs of the T123 are configured to AND standards. AC carrier or DC strain gage signal conditioning electronics can be used with the T123. Interconnecting cable assemblies are available as an option. In-house calibration of the T123 with SensorData electronics will be provided free of charge or with customer-supplied electronics for a fee.
Additional information
| Capacities | 50 Ib-in, 100 Ib-in, 200 Ib-in, 500 Ib-in, 1K Ib-in, 2K Ib-in, 5K lb-in |
|---|---|
| Size | Large |
| Weight | 14 Ibs |
Specifications
| Rated Capacity | 12K, 36K lb-in |
| Nonlinearity | 0.10% of rated output |
| Hysteresis | 0.10% of rated output |
| Nonrepeatability | 0.05% of rated output |
| Rated Output, typical | 2.00 mV/V |
| Zero Balance | +/-1% of rated output |
| Temperature Range, operating | -65 to +200 F |
| Temperature Range, compensated | +70 to +170 F |
| Temperature Effect on Output | 0.002% of load/F |
| Temperature Effect on Zero | 0.002% of rated output/F |
| Bridge Resistance, typical | 350 ohms |
| Excitation Voltage, bridge, typical | 10 VDC or VAC rms |
| Excitation Voltage, bridge, maximum (1) | 20 VDC or VAC rms |
| Insulation Resistance, bridge to case | >5000 megohms at 50 VDC |
| Maximum Load, safe (2) | 150% |
| Maximum Load, ultimate (3) | 300% |
| Torsional Stiffness, typical | See table next page |
| Extraneous Loads, maximum | See table next page |
| Number of Bridges | 1 |
| Weight | 40 lb |
| Construction | SAE 4340 Alloy Steel |
